MiravoBackup Power
Run a Tier III data center backup plant with diesel generators, fuel storage, cooling, wear and faults, served over MQTT, OPC UA and Modbus TCP.
A Tier III data center backup power plant. It has three diesel generators, a bulk fuel tank and a day tank, two chillers, two chilled-water pumps, a start-air compressor and a hall ventilation fan.
Asset ages are mixed: Genset A at 14,000 hours, Genset B at 6,000, the chilled-water pumps at 4,000 and the start-air compressor at 3,000. Genset C is new. All three gensets start stopped, so you can watch fuel and cooling before you start one.
Protocol scopes are set per area. Generators are served over Modbus TCP, fuel tanks over MQTT, and the cooling and support systems over OPC UA.
What's running
| Area | Assets |
|---|---|
| Power | Diesel generators |
| Fuel | Bulk tank, day tank |
| Cooling | Chillers, chilled-water pumps |
| Support | Start-air compressor, ventilation fan motor |
Use cases
- Readiness checks for standby generation before a real outage workflow.
- Fuel inventory and cooling load next to generator output.
- High-hour and low-hour standby assets side by side.
Launch
Console ⭢ Catalog ⭢ Backup Power ⭢ Launch. No restart required.
Verified
In Catalog, Backup Power shows 11 assets and 6 models. The Assets page keeps updating after launch.
Next
Connect a protocol
Hook a downstream system to the running factory.
Map into Litmus Edge
Map this template into Litmus Edge.
Was this page useful?
Last updated on
Commercial Building
Run a three-floor office tower with rooftop HVAC, a central plant, a heating loop and emergency power, served over MQTT, OPC UA and Modbus TCP.
District Heating
Run a city heat network with gas boilers, a thermal accumulator, trunk pumps and four customer substations, each with seasonal demand and its own pipe delay.